Match the symptom, then work through the safe checks.
1. What best matches what you observe?
2. Complete only the checks that are safe for you.
Show stop conditions
- Water is above normal level
- Appliance fills while off
- Internal sensor access is required
Likely causes
- Pressure or water-level sensor is abnormal
- Pressure path may be blocked internally
- Foam affects level detection
- Inlet or drain changes level unexpectedly
Quick checks, in order
Check for visible overfill
Close water if the level is rising abnormally.
Run one drain attempt
Retained water can keep the signal active.
Eliminate excess detergent
Foam can affect pressure readings.
Do not bypass level protection
Sensor diagnosis needs service.
What happens when E08 appears?
Close water and do not restart.
Sensor, hose, wiring, or control may report incorrectly.
Check siphoning, inlet leakage, and drain installation.
Stop and get qualified help when
- Water is above normal level
- Appliance fills while off
- Internal sensor access is required
Official support and model manuals
Use the full model number from the rating label. The manufacturer manual is the deciding reference when codes differ by region or product family.
Frequently asked questions
What does E08 mean on a Bosch dishwasher?
On many model families, E08 indicates that the water level is too low for heating. Confirm the exact model and region because the same display can be used differently.
Can I clear E08 by unplugging the dishwasher?
A short power reset may clear a temporary state, but it will not fix a blocked hose, leak, failed sensor, motor, heater, or wiring fault. Stop if the code returns.
Should I replace a part based only on the code?
No. A code identifies a system or condition, not always the failed component. Complete safe external checks and use the model-specific manual or qualified service.